🔥 ​​"Final Countdown! U.S. Tariff Hike 104% or 145% or... Now LIVE! Lock Original Prices Before April 30 – Prices Skyrocket 35%+ on May 1! 🚨 Act Now or Pay More!"​​ RhinoCrawler RM-S12 / RM-S20 is an extremely torque dense and lightweight choice with exceptional startup! It has more mounting positions, beefier wire retainer, and thicker back iron. RM-S12/20 is very difficult to produce, and it is currently the smallest

size of the 2812/2820 stator, the outer

size of the RM-S12 stator 2812 is only 35x24mm! RM-S12 stator 2820 is only 35x32mmIn addition, it adopts a specially customized dual tile strong magnetic design, which makes the motor lightweight and has stronger explosive power on the basis of small size! AM32 custom firmware. It's optimized for crawler and makes your car run supers mooth and quiet, but it is also suitable for a variety of 1/8 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 10A(VE80A), 3A(VE40A) to apply the high torque servo. In addition, the e-Switch that comes with it avoids failures caused by harsh environments. AM32 custom firmware Sinewave startup allows the motor smoothly at ultra-low speeds Variable drive frequency Low voltage, throttle loss and stalled rotor protection High-performance 32-bit MCU E-switch with long life and waterproof Specs Product Num.: A3100 Battery: 2-4S/40A, 2~8S/80A Current: 40/80A cont. BEC: 40A - max 10A, output /80A - max 10A, output 5.2~8.2V adjustable by DIP switch Waterproof: ESC not supported / e-switch supported FAN: not include, solder pads for power is reserved Connectors: not include Wires: battery 14AWGx150mm, output 14AWGx150mm, signal 250mm and e-switch 120mm Dimensions: 25x13x11mm @40A / 60x29x15mm @80A (without wires) S12 Specs: KV: 1470KV / 1900KV / 2340KV 14 pole 12 slot stator 8.4V -16.8V (2-4S) LiPo 1/8" D (3.17mm) shaft output 25mm Mounting holes for M3 screws 84g with wires, without connector 35mm diameter x 24mm long 28x12mm stator S20 Specs: KV: 1450KV / 1800KV / 2220KV 14 pole 12 slot stator 8.4V -16.8V (2-4S) LiPo 1/8" D (3.17mm) shaft output 25mm Mounting holes for M3 screws 120g with wires, without connector 35mm diameter x 32mm long 28x20mm stator